CIMS论文的天地

循环流化床颗粒团更新传热模型的修正

注意：本论文已在《动力工程》2001,21(5):1426-1429,1416发表
使用者请注明论文出处
苏亚欣 骆仲泱 岑可法
（浙江大学热能工程研究所，杭州，310027）

摘 要: 对颗粒团更新传热模型做了修正，引入新的床内流动特性的研究结果，改进了颗粒团覆盖壁面的百分比和颗粒团—壁面之间的气膜厚度的表达式，使之与床的宏观运行参数以及床体、床料的参数相联系，从而避免了前人模型中凭经验来确定一个比例系数的缺陷。对于弥散相和壁面间的辐射传热，考虑到了它们的直接辐射和弥散相辐射到颗粒团、再经颗粒团反射到壁面的传递过程。模型计算结果和有关实验数据的对比吻合较好，说明本文的修正模型是合理的。
　
关键词: 循环流化床 传热模型 修正

Modification to the CFB Cluster-Renewal Heat Transfer Model

Yaxin Su Zhongyang Luo Kefa Cen
( Institute of Thermal Power Engineering, Zhejiang University, Hangzhou, 310027 )

Abstract: Based on the Cluster Renewal Model of the particle motion in a CFB riser, the authors developed a revised heat transfer model, which introduced the latest research results of the hydrodynamics of the suspension flow in CFB. This model divided the heat transfer into two parts, which are due to the transient heat conduction by the covered clusters and the convection between the uncovered wall and the dispersed phase. Radiation at high temperature was regarded as being additive. The fraction of the covered wall by clusters and the thickness of the gas gap between clusters and wall were revised by a new formula, which is a function of the operating condition and the particle properties. The Radiation between the dispersed phase and the uncovered wall included not only the direct radiation to the uncovered wall, but also the radiation to the clusters and then reflected to the uncovered wall. The model results showed good agreement with the published experimental data, which proved the modification was reasonable.
Keywords: circulating fluidized bed heat transfer model modification

1、浏览PDF格式全文需要使用软件－－Abode Acrobat(由于软件较大并常见,我站不提供下载)

2、下载论文全文请点击鼠标右键“另存为”或使用网络蚂蚁下载(35KB)

1、方形旋风分离器内颗粒浓度分布特性的实验研究

2、方形分离器内部两相流场的PDA实验研究

3、钉肋肋列传热的最小熵产优化分析

4、方形冷却型分离器内壁面和两相流间的传热理论模型

5、方形旋风分离器内气固两相流湍流特性的研究

6、燃烧空气散布角对高温空气燃烧影响的数值研究

　更多相关论文请点击本站的<<<站内全文搜索>>>查找

>>>>参加更多投票调查请点击！