CIMS论文的天地

 

方形分离器内部两相流场的PDA实验研究

注意:本论文已在《中国电机工程学报》2001,21(2):42-45发表
使用者请注明论文出处
苏亚欣 周劲松 骆仲泱 岑可法
(浙江大学热能工程研究所,杭州,310027)

摘 要: 应用三维颗粒动态分析仪(3D-PDA)对方形下排气分离器内的气固两相流场进行了测试,得到了几种工况条件下的流场矢量分布。研究发现分离器方腔内的流场偏离其几何中心,并呈中间为强旋流动和边壁附近为弱旋的准自由涡区的特点,且在边角处存在局部小旋涡。不等温流场比等温流场要均匀一些,但旋流强度减弱,分离效率降低。研究结果对于分析分离器的分离机理和结构优化有一定的指导意义。 
关键词: 方形下排气旋风分离器 气固两相流 3D-PDA

An experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by 3D-PDA

SU Yaxin ZHOU Jinsong LUO Zhongyang CEN Kefa
( Institute of Thermal Power Engineering, Zhejiang University, Hangzhou, 310027 )

Abstract: Three dimensional Particle Dynamic Analyzer (3D-PDA) was employed to measure the gas-solid two-phase flow in a lab-scale square cyclone separator with downward gas exit under 4 cases of different inlet velocity and particle concentration. The particle used in the test was glass beard of mean diameter 30~40mm. It's found that the center of the flow field deviated from the geometric center of the cyclone. The flow fields showed a feature of Rankine eddy, i.e. strongly swirling region in the central part and pseudo-free eddy region of weak swirling intensity near the cyclone wall. Local vortex existed at the corners where the flow changed its direction sharply. When the cyclone wall was heated and the suspension temperature was elevated, it's found that the flow field became more uniform than that under room-temperature condition. The local vortex at the corners were weakened and the swirling intensity became poorer which led to a decreased total mean separation efficiency from about 81% to 76.5%. The results of this paper provide a further understand of the separation mechanism and guidance for the optimization of the square cyclone separator structure.
Keywords: square cyclone separator with downward; gas exit gas-solid suspension; 3D-PDA

1浏览PDF格式全文需要使用软件--Abode Acrobat(由于软件较大并常见,我站不提供下载)

2、下载论文全文请点击鼠标右键“另存为”或使用网络蚂蚁下载(86KB)


本站收录的本文作者的其他论文:

1、方形旋风分离器内颗粒浓度分布特性的实验研究

2、钉肋肋列传热的最小熵产优化分析

3、循环流化床颗粒团更新传热模型的修正

4、方形冷却型分离器内壁面和两相流间的传热理论模型

5、方形旋风分离器内气固两相流湍流特性的研究

 更多相关论文请点击本站的<<<站内全文搜索>>>查找

欢迎您参加讨论,发表您对此论文及其研究领域的看法!
(请在发言时在标题中使用所点评的论文的题目或研究方向,这样方便大家浏览!)

返回首页 | CIMS论文 | 并行工程 | 虚拟制造 | 敏捷制造 | 其他论文 | 项目开发 | 学术资源 | 站内全文搜索 | 免费论文网站大全 |

line.gif (4535 字节)

为了更好的为大家服务,欢迎您参加本站的投票调查

>>>>参加更多投票调查请点击!

本站永久域名:http://www.cimspaper.com欢迎访问

注意:本站内容未经书面允许不得转载

All rights reserved, all contents copyright 2000-2019
本站自2000年3月总网页访问量为